HMD Barbie Phone (US) user guide
Skip to main content
Set up and switch on your phone
Nano-SIM
Important: This device is designed to be used with a nano-SIM card only. Use of incompatible SIM cards may damage the card or the device, and may corrupt data stored on the card.
Note: Switch the device off and disconnect the charger and any other device before removing any covers. Avoid touching electronic components while changing any covers. Always store and use the device with any covers attached.
Open the back cover
- Put your fingernail in the small slot at the bottom of the phone, lift and remove the cover.
- If the battery is in the phone, lift it out.
Insert the SIM card
- Slide the SIM card holder to the left and open it up.
- Place the nano-SIM in the slot face down.
- Close down the holder and slide it to the right to lock it in place.
Insert the memory card
- Slide the memory card holder to the left and open it up.
- Place the memory card in the slot face down.
- Close down the holder and slide it to the right to lock it in place.
- Put back the battery.
- Put back the back cover.
Use only compatible memory cards approved for use with this device. Incompatible cards may damage the card and the device and corrupt data stored on the card.
Important: Do not remove the memory card when an app is using it. Doing so may damage the memory card and the device and corrupt data stored on the card.
Tip: Use a fast, up to 32 GB microSD memory card from a well-known manufacturer.
Note: Pre-installed system software and apps use a significant part of memory space.
Switch on your phone
Press and hold .